На главную
Видео добавленное пользователем “wyattoneable”
98 Chevy crank no start
My 1998 Chevy truck cranks but no start. I was surprised what fixed the problem.
Просмотров: 9853 wyattoneable
Allison 1000 transmission service
In preparation for a road trip I serviced the transmission on my 2005 Chevy Duramax with the Allison 1000 transmission.
Просмотров: 3925 wyattoneable
1998 Chevy 5.7 cold weather no start (fix)
In this final video we correct the problem for a cold weather no start/long crank time. Be sure to look at the end credits because I had some help from some great guys.
Просмотров: 3047 wyattoneable
Kubota fuel gauge repair
I've had this tractor for about a year and the fuel indication has never worked. Here we find the problem...it was an easy fix.
Просмотров: 9624 wyattoneable
How I installed a winch on my trailer
Not a "how to" video, it's just me sharing some short clips of a project I recently completed. Sorry about the quality of the video, I'm still working out the bugs on my new editor.
Просмотров: 2849 wyattoneable
How to check the transmission oil level on a 2005 Dodge Magnum
With the cars of today it is almost impossible to do any service work, diagnostic, or repair without some kind of a scanner, and in some cases a scope as well. This is an over complicated world we live in but as a DIY'er we either step up to the plate or we let the professionals do it. As for me, I will learn as much as I can and proceed down this path to understand all I can about my cars and take care of them the best that I can.
Просмотров: 5200 wyattoneable
1998 Crank, no start (again)
My 1998 Chevy 5.7 liter with 191,000 miles has a long crank time during cold weather. It has gotten worse to the point that it won't start at all. I experimented by disconnecting the MAF and found a possible fix. But, we won't know for sure until it gets cold again.
Просмотров: 9775 wyattoneable
5.7 liter Chevy no start in cold weather with a special guest
A lot of work has been done to check everything possible to find out why this truck has a hard time starting when the weather is cold. Long crank times and a no start situations depending on how cold it is. In this video we complete the last two checks before calling the diagnosis. Come along with my special guest and I and see what we determine is the cause of this problem. Mikes channel: https://www.youtube.com/channel/UCQ-u93-0e3YTkrc8Lbi87iQ
Просмотров: 3759 wyattoneable
Preppers unplugged challenge
My attempt at 48 hours off grid. Beware, blood, nudity and a lot of "Assets" http://www.youtube.com/user/bctruck http://www.youtube.com/user/BexarPrepper http://www.youtube.com/user/BugOutVehicles http://www.youtube.com/user/houseoffire72 http://www.youtube.com/user/M0D0C42 http://www.youtube.com/user/OBXSOLWIND http://www.youtube.com/user/PetPrepper http://www.youtube.com/user/thebrooklynprepper
Просмотров: 2549 wyattoneable
P1351, crank, no start. (Part two) The Fix!
In part two of this repair we continue to disgnose my crank, no start on the 1998 Chevy truck. Scannerdanner https://www.youtube.com/user/ScannerDanner South Main Auto https://www.youtube.com/channel/UCtAGzm9e_liY7ko1PBhzTHA https://www.youtube.com/user/motoYam82
Просмотров: 8484 wyattoneable
Wyatt's dream shop (2)
I finially got my concrete poured. This is a long time coming.
Просмотров: 953 wyattoneable
Removing an old water tank with the L39
Removing an old water tank with the L39 Kubota
Просмотров: 3525 wyattoneable
Wyatt's dream shop (bathroom)
Building a shop complete with a bathroom
Просмотров: 598 wyattoneable
EMP proof Harley
Not a "how to" video, but a project I thought I'd share.
Просмотров: 1419 wyattoneable
L39 Kubota
Thank you Jim (jimsequipmentshed) and Doctor (UNSERDOC) for answering some questions about Kubota tractors. Thanks to you guys I now have a tractor of my own.
Просмотров: 1969 wyattoneable
Dodge Magnum code P0406
Join me on my first diagnostic adventure Scannerdanner https://www.youtube.com/user/ScannerDanner/videos johnsolar283 or the great intro! https://www.youtube.com/channel/UCfdjFTodbEQzHOkujBcISiQ/videos
Просмотров: 2099 wyattoneable
Hauling water for the last time.
The need to haul water will soon end as our city water line is nearing completion. Here I how I've been hauling water for the past 7 years.
Просмотров: 2626 wyattoneable
Fog lamps don't work (2005 Dodge Magnum) Troubleshooting
I troubleshoot and identify why the fog lamps won't work on a 2005 Dodge Magnum.
Просмотров: 586 wyattoneable
Fuel rotation
This is how I rotate my fuel storage
Просмотров: 616 wyattoneable
2005 Dodge Magnum Clock spring removal
I broke the self cancelling part of the clock spring. I show how to remove the clock spring, but the replacement part is so expensive I decided not to replace it.
Просмотров: 872 wyattoneable
P1351 crank, no start (part one)
P1351 with a crank, no start and help from scannerdanner forum
Просмотров: 9343 wyattoneable
Wyatt and Kraut move to Tennessee.
We are trying a test to live at the retreat home to ensure we will be happy here.
Просмотров: 924 wyattoneable
Wyatt's dream shop (4) Doors
The build contines with garage doors being installed.
Просмотров: 3701 wyattoneable
Shop King Vise
I found an old vise in great condition
Просмотров: 440 wyattoneable
Improved test light clamp
I made my own improved clamp device for a automotive test light. The idea came from South Main Auto channel, who in turn was sent a test light from a viewer with an improved clamp. South Main Auto: https://www.youtube.com/channel/UCtAGzm9e_liY7ko1PBhzTHA Dave Canterbury: https://www.youtube.com/channel/UCfa-XVztQrDlf-2v1UUdkwg
Просмотров: 330 wyattoneable
Unboxing from bctruck
Rocket stove
Просмотров: 585 wyattoneable
Emergency water storage
A water tank and related plumbing to deliver water to our house in case we lose electricity to our pump.
Просмотров: 517 wyattoneable
A home fueling station
I moved my fuel storage to an outside building to increase the room in my main shop. The move required a new way to dispense fuel. This is what I came up with.
Просмотров: 556 wyattoneable
Moving dirt with my L39 Kabota and a 1973 Chevy dump truck
I wasn't going to film this but since my buddy Mike filmed a video moving dirt I thought I might as well film the project. It's just me working guys, nothing special unless you like Kabota tractors and old dump trucks.
Просмотров: 552 wyattoneable
1973 Chevy dump truck brakes (fail)
Earn $100 if you can find brake rotors for my 1973 dual rear wheel 1 ton dump truck!
Просмотров: 775 wyattoneable
What to do if you wire a GM alternator and the engine won't shut off
I purchased a 1955 Chevy truck and the alternator was not wired. After wiring the alternator and starting the engine, the engine would not shut off. I found a fix on Chis Craft's channel and applied his fix to my truck. It works and it's simple.
Просмотров: 451 wyattoneable
Wyatt's Traum Garage Tour
I share the progress of my garage build and speak in (terrible) German
Просмотров: 7042 wyattoneable
A DIY attempt at repairing rust on a 1955 Chevy truck (Part one)
I'm not a professional but I do my best at replacing parts of a body panel to rid my truck of some rust.
Просмотров: 531 wyattoneable
Retreat part 2 (water tank)
Hauling water to the retreat
Просмотров: 794 wyattoneable
Ultimate fuel storage
I moved all gasoline related items from my garage to a separate building that is used to store fuel. With the incorporation of the fuel pump, I now have a working (gravity feed) dispensing system.
Просмотров: 278 wyattoneable
How I store my Cleco fasteners
Hello again. In this video I show you how I store my Cleco fasteners. I can't take credit for the idea but I wanted to share what I learned. If your interested in this tool just type "cleco" on eBay and you'll see many options to buy.
Просмотров: 363 wyattoneable
A good vice
I'm sharing the shop vice in response to a comment. http://www.youtube.com/user/bctruck
Просмотров: 382 wyattoneable
Spanky and 805 roadking swag
My wife attacks me during filming D6spanky: https://www.youtube.com/channel/UCVCwK0gsimLSO3llhGf0M2g 805roadking: https://www.youtube.com/channel/UCqzavCyo1aQaeJ-Trp_SmEw
Просмотров: 266 wyattoneable
Wyatt's dream shop (3) building
Continuation of my shop build
Просмотров: 9329 wyattoneable
Pin striping my truck
Rick Harris is a well known pin striper in the Nashville area. He was trained by a California striper, who was trained by the one and only Von Dutch.
Просмотров: 394 wyattoneable
Trailer axle fails
Moving from Florida to Tenessee on the last trip and a bearing fails.
Просмотров: 2552 wyattoneable
VR to BCtruck
Water storage
Просмотров: 201 wyattoneable
55 Chevy truck wood bed install (highlights)
For those of you who have been following along, I finished the body work on the cab corner and rear fenders, now we see the truck back from paint and I install a new wood bed. The paint job is terrible and will have to be redone, but the wood bed came out noce.
Просмотров: 275 wyattoneable
I lost my charge!
My alternator failed and as a DIY'er (self sufficient) I wanted to fix this myself. Thanks to the Scannerdanner channel and South Main Auto for helping me get back into auto repair! johnsolar283 for the graphics https://www.youtube.com/channel/UCfdjFTodbEQzHOkujBcISiQ/videos wolverineprepper for the music https://www.youtube.com/user/WOLVERINEprepper/videos scannerdanner: https://www.youtube.com/user/ScannerDanner/videos South Main Auto: https://www.youtube.com/channel/UCtAGzm9e_liY7ko1PBhzTHA/videos
Просмотров: 454 wyattoneable
Review of the Autel AL 319 affordable scan tool
A review of an inexpensive scanner that displays freeze frame data and live data. Amazon has them listed for less than $30 New Level Auto Channel: https://www.youtube.com/channel/UCNZty_jKwN_LJ6oNBcDlWig
Просмотров: 482 wyattoneable
A ride to Modoc County California
A group of us rode from Colorado to California
Просмотров: 1154 wyattoneable
Wyatt's dream shop (air compressor)
I installed and air compressor in the shop
Просмотров: 708 wyattoneable
Launch 7001 review from TOPDON
Sadly these are not produced by LaunchTech USA. Spoke to the rep today , these are strictly released as Chinese tools. Updates will not be available. Much like the other companies they will fade into the wind. They just try to get youtube personalities to get the subscribers to purchase the unit. For what it's worth Launch will be releasing a tool later this year that will look pretty much exactly the same as this tool but will have support known as their Millennium series. Model numbers will be different and the correct software will be available. At least they were free. But just a warning to the viewers that if you purchase the tool you will not have real support from Launch. Thanks for taking so much time for the video as always. Have an awesome day and keep em rolling. Keith DeFazio (ONBOARDtech333) OZZSTAR's review video: https://www.youtube.com/watch?v=G4ShsUnL7Sg&t=1s (Mike) the disgruntled mechanic review video: https://www.youtube.com/watch?v=_cv5AejNXhE
Просмотров: 375 wyattoneable
How I built a grinder stand for $10. (The cost of pipe).
The placement of my grinder on the workbench was not working out for me so I mounted the grinder on a mobile stand. Buckrun11 channel: https://www.youtube.com/channel/UC7o10DAI4NAaWA3CJWoKCjA
Просмотров: 276 wyattoneable
Sale at Sears
My local Sears store is closing and they have some cool stuff for cheap. I found a small storage rack that fits perfectly in my shop.
Просмотров: 346 wyattoneable